Rotax 912iS or 912ULS for Sling 2 ???

Talk about airplanes! At last count, there are 39 (and growing) FAA certificated S-LSA (special light sport aircraft). These are factory-built ready to fly airplanes. If you can't afford a factory-built LSA, consider buying an E-LSA kit (experimental LSA - up to 99% complete).

Moderator: drseti

TimTaylor
Posts: 1594
Joined: Tue Feb 21, 2017 7:17 pm

Re: Rotax 912iS or 912ULS for Sling 2 ???

Post by TimTaylor »

How do you drive an auxiliary generator?
Retired from flying.
Wm.Ince
Posts: 1080
Joined: Sun Nov 17, 2013 3:27 pm
Location: Clearwater, FL

Re: Rotax 912iS or 912ULS for Sling 2 ???

Post by Wm.Ince »

TimTaylor wrote:How do you drive an auxiliary generator?
With a Rotax 912iS.
Bill Ince
LSRI
Retired Heavy Equipment Operator
TimTaylor
Posts: 1594
Joined: Tue Feb 21, 2017 7:17 pm

Re: Rotax 912iS or 912ULS for Sling 2 ???

Post by TimTaylor »

drseti wrote:The 912 ULS generator puts out 15 amps. For avionics systems that put a heavy load on it, most of us supplenent this with the 20 amp aux gen.
How do you drive an auxiliary generator?
Retired from flying.
3Dreaming
Posts: 3107
Joined: Sun Jan 10, 2010 6:13 pm
Location: noble, IL USA

Re: Rotax 912iS or 912ULS for Sling 2 ???

Post by 3Dreaming »

TimTaylor wrote:
drseti wrote:The 912 ULS generator puts out 15 amps. For avionics systems that put a heavy load on it, most of us supplenent this with the 20 amp aux gen.
How do you drive an auxiliary generator?
Typically belt driven off a pulley added to the propeller flange. A small generator can also be added to the back of the gearbox on the accessory pad.
User avatar
drseti
Posts: 7227
Joined: Sat Nov 28, 2009 6:42 pm
Location: Lock Haven PA
Contact:

Re: Rotax 912iS or 912ULS for Sling 2 ???

Post by drseti »

My 20 amp aux mounts to the accy housing on the back of the gearbox.
The opinions posted are those of one CFI, and do not necessarily represent the FAA or its lawyers.
Prof H Paul Shuch
PhD CFII DPE LSRM-A/GL/WS/PPC iRMT
AvSport LLC, KLHV
[email protected]
AvSport.org
facebook.com/SportFlying
SportPilotExaminer.US
TimTaylor
Posts: 1594
Joined: Tue Feb 21, 2017 7:17 pm

Re: Rotax 912iS or 912ULS for Sling 2 ???

Post by TimTaylor »

I was just curious how you could spin two generators.
Retired from flying.
User avatar
drseti
Posts: 7227
Joined: Sat Nov 28, 2009 6:42 pm
Location: Lock Haven PA
Contact:

Re: Rotax 912iS or 912ULS for Sling 2 ???

Post by drseti »

At full current draw, the aux gen loads down the engine by 1/3 HP.
The opinions posted are those of one CFI, and do not necessarily represent the FAA or its lawyers.
Prof H Paul Shuch
PhD CFII DPE LSRM-A/GL/WS/PPC iRMT
AvSport LLC, KLHV
[email protected]
AvSport.org
facebook.com/SportFlying
SportPilotExaminer.US
User avatar
FastEddieB
Posts: 2880
Joined: Wed Jan 07, 2009 9:33 pm
Location: Lenoir City, TN/Mineral Bluff, GA

Re: Rotax 912iS or 912ULS for Sling 2 ???

Post by FastEddieB »

MrMorden wrote:[
We are on the same page. :)
...and...
Nomore767 wrote:Agreed!
Seriously guys, knock off all this Kumbaya stuff!

I came here for an argument!

Image
Fast Eddie B.
Sky Arrow 600 E-LSA • N467SA
CFI, CFII, CFIME
[email protected]
User avatar
drseti
Posts: 7227
Joined: Sat Nov 28, 2009 6:42 pm
Location: Lock Haven PA
Contact:

Re: Rotax 912iS or 912ULS for Sling 2 ???

Post by drseti »

"No you didn't. "
"Yes I did!"
The opinions posted are those of one CFI, and do not necessarily represent the FAA or its lawyers.
Prof H Paul Shuch
PhD CFII DPE LSRM-A/GL/WS/PPC iRMT
AvSport LLC, KLHV
[email protected]
AvSport.org
facebook.com/SportFlying
SportPilotExaminer.US
Nomore767
Posts: 929
Joined: Fri Jan 18, 2013 8:30 pm

Re: Rotax 912iS or 912ULS for Sling 2 ???

Post by Nomore767 »

FastEddieB wrote:
MrMorden wrote:[
We are on the same page. :)
...and...
Nomore767 wrote:Agreed!
Seriously guys, knock off all this Kumbaya stuff!

I came here for an argument!

Image
I can’t say anymore....I signed a Non Disclosure Agreement :wink:
3Dreaming
Posts: 3107
Joined: Sun Jan 10, 2010 6:13 pm
Location: noble, IL USA

Re: Rotax 912iS or 912ULS for Sling 2 ???

Post by 3Dreaming »

TimTaylor wrote:I was just curious how you could spin two generators.
The primary generator is built into the engine, leaving options for installing a secondary generator/alternator.
User avatar
drseti
Posts: 7227
Joined: Sat Nov 28, 2009 6:42 pm
Location: Lock Haven PA
Contact:

Re: Rotax 912iS or 912ULS for Sling 2 ???

Post by drseti »

The Rotax generator is really a cool design. (OK, I'll admit I'm a technology nerd.) They embed permanent magnets in the circumference of the flywheel. Thus, spinning magnetic field. Then, they place a total of seven stationary coils around the periphery of the flywheel housing. Since the coils are stationary, there's no need for slip rings or brushes.

The spinning magnetic field induces currents into the stationary coils. If you properly connect to a pair of coils spaced physically 180 degrees apart around the flywheel, you get a raw voltage. So, one pair of those coils generates power for one capacitive discharge ignition module. A second pair does the same for the other CDI module, and a third feeds the voltage regulator module that powers the main bus.

That leaves a single coil to produce a pulse of voltage each time the flywheel makes a revolution. And that pulse, students, drives the tachometer.

Pretty cool, no? Class dismissed.
The opinions posted are those of one CFI, and do not necessarily represent the FAA or its lawyers.
Prof H Paul Shuch
PhD CFII DPE LSRM-A/GL/WS/PPC iRMT
AvSport LLC, KLHV
[email protected]
AvSport.org
facebook.com/SportFlying
SportPilotExaminer.US
cam737
Posts: 136
Joined: Mon Jan 22, 2018 3:10 pm

Re: Rotax 912iS or 912ULS for Sling 2 ???

Post by cam737 »

Oh yeah. I knew that. :shock:

dr...my eyes are so glazed over I can barely type. But, I got through the first 2 sentences. :)
cam737
Sling 2 Build
[email protected]

swa
cam737
Posts: 136
Joined: Mon Jan 22, 2018 3:10 pm

Re: Rotax 912iS or 912ULS for Sling 2 ???

Post by cam737 »

Wm.Ince wrote:Regarding the choice between ULS and iS, something that should not be overlooked is the demand on the aircraft electrical system.
Besides wing strobes and position lights, I believe the Sling is equipped with 2 taxi lights and 2 landing lights. If the autopilot is engaged, will the ULS easily handle that load or will the limit be pushed?
Bill, I was concerned that my Sling 2 would need a really long extension cord for everything to work. Midwest Sky Sports has built Slings with higher electrical power requirements. The plan is to use a 40 amp external alternator.

Don't ask me any questions. I don't know the difference between 'positive' and 'negative', let alone the spinning magic things the dr talks about!

I just want everything to work great and last a long time!

Cam
cam737
Sling 2 Build
[email protected]

swa
User avatar
drseti
Posts: 7227
Joined: Sat Nov 28, 2009 6:42 pm
Location: Lock Haven PA
Contact:

Re: Rotax 912iS or 912ULS for Sling 2 ???

Post by drseti »

cam737 wrote: I don't know the difference between 'positive' and 'negative', let alone the spinning magic things the dr talks about!
Not magic, Cam, magNETic!
;)
The opinions posted are those of one CFI, and do not necessarily represent the FAA or its lawyers.
Prof H Paul Shuch
PhD CFII DPE LSRM-A/GL/WS/PPC iRMT
AvSport LLC, KLHV
[email protected]
AvSport.org
facebook.com/SportFlying
SportPilotExaminer.US
Post Reply