ADSB-B in and out

Constructive topics of interest related to aviation that do not match the other section descriptions below (as long as it is somewhat related to aviation, flying, learning to fly, sport pilot, light sport aircraft, etc.). Please, advertisements for Viagra will be promptly deleted!"

Moderator: drseti

User avatar
dstclair
Posts: 1043
Joined: Thu Mar 06, 2008 11:23 am
Location: Allen, TX

Re: ADSB-B in and out

Postby dstclair » Sat Jun 02, 2018 7:53 am

Good point. In this case, Garmin allows the installation to be done in accordance with part 43, which includes an A&P. I believe the installation manual or TSO would need to specify the subsection if a authorized repair station was required. In this particular plane, the manufacturer has approved the equipment and the Sting manual allows an A&P to do this type of work. Of course, the particular A&P would have to be trained and/or have done an installation similar to this.
dave

User avatar
ShawnM
Posts: 355
Joined: Sat Nov 11, 2017 9:59 pm
Location: Clearwater, FL / KZPH

Re: ADSB-B in and out

Postby ShawnM » Sun Jun 03, 2018 7:57 am

dstclair wrote:....... Also, installing the GPS antenna is dead simple on a Sting. Just mount it on top of the panel.

This shop is taking advantage of you.


The GA-35 GPS antenna that is part of the GDL-82 requires a ground plane. Unless the area on top of your "panel" is metal and at least 15" in diameter it wont work adequately. I had a few signal issues after my initial installation and the placement of my GPS antenna. It wants a clear view of the sky with no possibility of shadowing and a large ground plane. I had a few failures on some of my PAPR reports during testing. I have since moved my GPS antenna to the top of the aircraft and it has worked PERFECT on every flight and PAPR report since them. ADS-B is not where you want a "marginal" antenna signal.

And yes, it can use your existing transponder antenna which already has a ground plane. But I would check the freq range of the transponder antenna you have to be sure it covers the 978 MHZ band. Mine didn't and again I didn't want a "marginal" signal so I installed the Rami AV-74. Just food for thought.


Return to “Hangar Talk”

Who is online

Users browsing this forum: No registered users and 2 guests